X Series E70 X5 3.0Si (N52K) OFFRD
Note:
The jacking points on the left side are shown.
Align special tools 33 5 181 and 33 5 182 to rear axle carrier.
Support rear axle carrier by operating workshop jack 00 2 030 .
Version with Dynamic Drive:
Remove underbody panelling (rear section).
Important!
Pay attention to control lines (2) when lowering and raising.
Hydraulic lines must not be kinked/tensioned/bent!
1 = Banjo bolts
Important!
Lower rear axle carrier only until such stage that the rubber
mounts can be changed.
Remove front and rear compression struts and carefully lower rear
axle carrier approx. 50 mm.
After installation:
•
Activate and fill air suspension system
•
Bleed braking system
RA Lowering/raising rear axle carrier (special tool SWZ00-2040)
BMW AG - TIS
06.02.2013 19:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
