X Series E70 X5 3.0Si (N52K) OFFRD
33 32 051
Removing and installing/replacing left or right
push rod/integral link
Note:
If the integral link is detached from the wheel carrier or swinging
arm, it is necessary after reinstallation to carry out a wheel/chassis
alignment check.
Necessary preliminary tasks:
•
Remove rear wheel.
•
Tension coil spring (and leave on vehicle)
•
Version with ride-height control: Deactivate and drain air
spring system
Release nut (1) and remove screw.
Release screw (2) and remove integral link (3).
Installation:
Replace self-locking nut.
First install swinging arm hand-tight, then tighten down screw (2).
Tighten screw/bolt connections in normal position.
Tightening torque (nut) 33 32 3AZ
.
Tightening torque (bolt) 33 32 4AZ
.
After installation:
•
Activate and fill air suspension system
•
Perform chassis alignment check
RA Removing and installing/replacing left or right push rod/integral link
BMW AG - TIS
06.02.2013 19:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -