X Series E70 X5 3.0Si (N52K) OFFRD
Important!
Mark any worn brake pads.
In the event of one-sided brake pad wear, do not change
brake pads round.
Remove outer brake pad.
Inner brake pad is located with its spring in the piston.
Clean brake pads.
Do not grease backs of brake pads sleeve.
Check minimum brake disc thickness:
-
Position special tool 34 1 280 at three measuring points in
area (1) and measure.
-
Compare measurement result and lowest value with setpoint
value.
New brake pads may only be installed if the brake disc thickness
is greater than or equal to the minimum brake disc thickness (MIN
TH).
Note:
The minimum thickness of the brake disc is designed so that it
holds over the service life of a further set of brake pads if it is
greater than or equal to the minimum brake disc thickness (MIN
TH).
Check dust sleeve (1) for damage and replace if necessary.
Important!
Dust sleeve must not come into contact with Plastilube as this
may cause the dust sleeve to swell.
Clean contact surface (2) of brake piston and apply a thin coating
of Plastilube.
Clean contact surfaces (1...2) of brake pad tee heads/brake
caliper housing and coat with Plastilube.
RA Removing and installing or replacing brake pads on both rear disc brakes (Teves
BMW AG - TIS
06.02.2013 19:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
