X Series E70 X5 3.0Si (N52K) OFFRD
34 21 320
Removing and installing or replacing both
rear brake discs
Special tools required:
•
34 1 280
Necessary preliminary tasks:
•
Remove wheels
•
Remove and clean brake pads
After completing work:
•
Adjusting handbrake
•
Read and comply with notes on braking in new brake discs /
brake pads.
Check minimum brake disc thickness:
-
Position special tool 34 1 280 at three measuring points in
area (1) and measure.
-
Compare measurement result and lowest value with setpoint
value.
New brake pads may only be installed if the brake disc thickness
is greater than or equal to the minimum brake disc thickness (MIN
TH).
If the brake discs are replaced, you must also fit new brake pads.
Always replace brake discs in pairs.
Release screws (1) and detach brake caliper mounting bracket.
Installation:
Tightening torque 34 21 2AZ
.
RA Removing and installing or replacing both rear brake discs
BMW AG - TIS
06.02.2013 19:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
