X Series E70 X5 3.0Si (N52K) OFFRD
Cable for emergency release (1) must be removed with actuating
unit.
Press both detent lugs together and press cable for emergency
release (1) downwards.
Unclip cable for emergency release from guides on rear axle.
Release screws (1) and remove heat shield (2).
Release stabilizer at bearing points and swing downwards.
Release screw (1) and remove spring clip (2) on left and right.
Installation:
Tightening torque 34 41 1AZ
.
Push in core of parking brake cable in direction of expander
lock (2) as far as it will go and grip firmly.
Press nipple (1) down with a screwdriver.
Pull handbrake cables out of wheel carrier.
RA Removing and installing/replacing actuating unit with control unit for parking b
BMW AG - TIS
06.02.2013 19:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
