X Series E70 X5 3.0Si (N52K) OFFRD
Remove left partition wall for equipment compartment.
Unclip retaining bar (1) and remove both brake lines (2) from
guides.
Important!
Do not bend brake lines.
Pull brake master cylinder with brake booster 30 mm forwards.
Installation:
Retighten brake lines on brake master cylinder.
Tightening torque 34 32 1AZ
.
Feed out bearing block for pedal assembly.
Replacement:
•
Modify brake light switch
•
Modify brake pedal spring
•
Modify pedal rubber
RA Removing and installing (replacing) complete bearing block for foot pedal
BMW AG - TIS
06.02.2013 20:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
