X Series E70 X5 3.0Si (N52K) OFFRD
37 12 012
Carrying out ride-height-calibration
Note:
Ride-height-calibration must be carried out after the following
work:
•
Removal/replacement of ride-height sensor or its control rod
•
Replacement of wiring harness
•
Replacement of air supply unit control unit
•
Replacement of Vertical Dynamics Management control unit
Connect BMW diagnosis system.
Switch on ignition.
Carry out ride-height-calibration (menu item: "Service function").
Version with Run Flat Indicator: initialize Run Flat Indicator
Version with Tyre Pressure Control: carry out resetting
RA Carrying out ride-height-calibration
BMW AG - TIS
06.02.2013 20:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
