X Series E70 X5 3.0Si (N52K) OFFRD
41 21 510
Replacing front left door pillar (front side
panel removed)
Read contents of Body, General.
For stripping and rigging operations, refer to texts on KSD
CD (FR number 41 21 510).
Spot-weld bonding is used on this vehicle. Observe specific
procedure.
Remove or cover those vehicle components in the repair area
which are susceptible to heat or dust.
Use only approved spot-welding apparatus for repairs!
Place vehicle on straightening bench.
Following new body parts are required (refer to Electronic Parts
Catalogue ETK):
-
(1) A-pillar, outer
-
(2) Support carrier, wheel arch, outer
-
(3) Shaped parts (not pictured)
Open weld joints in area (1).
Mark severance cut in accordance with measurement a and cut
support carrier.
Measurement a = approx. 50 mm in front of bore dia. 20 mm.
Open weld joints in area (1).
Installation:
Weld in reinforcement plate at severance cut.
RA Replacing front left door pillar (front side panel removed)
BMW AG - TIS
06.02.2013 21:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -