bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

2 RA Replacing Rear Left Outer Wheel Arch Section (rear Left Side Panel Removed)|Page 1488 > < 1 RA Replacing Complete Rear Left Wheel Arch (rear Left Side Panel Removed)|Page 1486
Page 1
background image

41 14 502

Replacing rear left outer wheel arch section
(rear left side panel removed)

Read contents of Body, General.

For stripping and rigging operations, refer to texts on KSD
CD (FR number 41 14 502).

Spot-weld bonding is used on this vehicle. Observe specific 
procedure.

Remove or cover those vehicle components in the repair area
which are susceptible to heat or dust.

Use only approved spot-welding apparatus for repairs!

Following new body parts are required (refer to Electronic Parts
Catalogue ETK):

(1) Reinforcement, C-pillar, bottom

(2) Wheel arch, rear, outer half

(3) Shaped parts, wheel arch (not pictured)

Mark severance cuts in accordance with specified measurements
and cut.

Important!

Cut outer metal sheet only.

Measurement a =70 mm below 15 mm dia. bore

Measurement b = 130 mm

Installation:

Weld in reinforcement plates at severance cuts.

RA  Replacing rear left outer wheel arch section (rear left side panel removed)

BMW AG - TIS

06.02.2013  21:18

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

2 RA Replacing Rear Left Outer Wheel Arch Section (rear Left Side Panel Removed)|Page 1488 > < 1 RA Replacing Complete Rear Left Wheel Arch (rear Left Side Panel Removed)|Page 1486