X Series E70 X5 3.0Si (N52K) OFFRD
41 62 007
Removing and installing rear lid lower section
Read contents of Body, General.
For stripping and rigging operations, refer to texts on KSD
CD (FR number 41 62 007).
Necessary preliminary tasks:
•
Remove trim for rear lid lower section.
•
Disconnect all cable plug connections and pull wiring harness
out of rear lid.
Open rear lid (1) until screw (2) is accessible (risk of injury by
spring tension).
With rear lid in this position, release screw (2) and insert in bore of
support (3).
Tightening torque 51 24 7AZ
.
Release screws (1) on both sides of vehicle.
Tightening torque 41 62 8AZ
.
Installation:
Screw down rear lid lower section with fitting screws. This
dispenses with the need for adjustment after installation.
RA Removing and installing rear lid lower section
BMW AG - TIS
06.02.2013 21:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
