X Series E70 X5 3.0Si (N52K) OFFRD
Important!
Risk of damage!
If you are not careful, the retaining spring may be bent to such
an extent that the entire drive spindle will have to be replaced.
Press drive spindle (1) against ball pin (2) in order to relieve
strain on retaining spring (3) at ball pin (2).
Insert screwdriver under retaining spring (3).
Pull out retaining spring (1) approx. 2-3 mm.
Detach spindle foot (2) in direction of arrow.
Repeat procedure at other end of spindle drive and remove.
Note:
To prevent the plug connections from being skewed in the body, fit
these plug connections with cable guide (1)* and feed out
carefully.
*Cable guide (1) is included in the spindle drive spare part; if
necessary, secure plug connections with adhesive tape into a
narrow strand.
Important!
Risk of damage!
Do not press on spindle drive at an angle or twisted.
Installation:
Press ball socket (1) onto ball pin (2) until retaining
spring (3) engages correctly (clicking sound).
RA Removing and installing/replacing electric spindle drive for rear lid on left or
BMW AG - TIS
06.02.2013 22:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
