X Series E70 X5 3.0Si (N52K) OFFRD
Important!
Risk of damage!
Tape off rear lid with suitable protective film (1).
Lever off rear light with special tool 00 9 318 in direction of
arrow.
Installation:
Clean bonding surface and allow to dry.
Make sure gap is uniform all round between rear light (2) and
rear lid.
Installation:
Position lugs (1) of rear light exactly over side edge of rear lid.
In case of replacement or partial detachments, lay butylene
tape (2) (sourcing reference: BMW Parts Service) depending on
the conditions on rear light again.
Replacement:
If necessary, remove bulbs.
RA Removing and installing/replacing left or right tail light (on rear lid)
BMW AG - TIS
07.02.2013 03:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
