X Series E83 X3 2.0d (M47T2) OFFRD
If injectors are stuck tight, mount special tool 13 6 100 on
injector connection.
Pull out injector by means of short back and forth movements.
Important!
Movement clearance of disassembly road is limited by flank
clearance of flange to a few degrees.
Note:
Check whether sealing ring (1) has been retained on removed
injector.
If this is not the case, the sealing ring (1) must be removed from
the cylinder head.
Installation:
Replace sealing ring (1) on injector (2).
Replace sealing ring on injector stem.
Observe installation position of flange (3).
Apply a light coating of highly temperature-resistant grease to
injector stem.
(BMW part number 83 23 0 441 070)
Before installing injectors, clean injector stems.
If one or more injectors have been replaced, injector rate
adjustment must be carried out:
-
Connect DIS Tester
-
Identify car
-
Select "Function selection"
-
Select "Service functions"
RA Removing and installing/replacing all injectors in fuel injection system (M47TU,
BMW AG - TIS
04.02.2013 11:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
