X Series E83 X3 2.0d (M47T2) OFFRD
31 50 001
Removing and installing/replacing front
differential
Necessary preliminary tasks:
•
Remove front underbody protection
•
Drain and dispose of front differential oil
•
Remove left output shaft
•
Press right output shaft approx. 7 to 8 cm out of front
differential
•
Remove front propeller shaft
•
Replacement only:
-
Replace front axle output flange on transfer case
Note: Replace the output flange to ensure a clean seal
on the transfer case.
Important!
Grip front differential firmly while releasing last bolt in order to
avoid damage caused by the differential falling.
Version with automatic transmission: If necessary, disconnect
hydraulic lines from oil sump.
Release screws (1).
Tightening torque 31 50 7AZ
.
Detach front differential from oil sump and carefully feed out
towards bottom.
Installation:
Replace O-ring if necessary.
Coat O-ring with front differential oil.
RA Removing and installing/replacing front differential
BMW AG - TIS
04.02.2013 13:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
