X Series E83 X3 2.0d (M47T2) OFFRD
51 47 315
Removing and installing/replacing front
carpet for passenger compartment
Necessary preliminary tasks:
•
Remove instrument panel trim
•
Remove left/right front seat
•
Remove front left/right entrance cover strip
•
Remove accelerator pedal module
Cut out carpet (1) at cutting edge (2) on left/right.
Important!
Make the cut as far as possible in the direction of the middle
of the car to ensure that the cutting edges are covered by the
storage compartment/instrument panel.
Pay attention to cables when cutting (risk of damage).
If necessary, guide cable back through carpet (1).
Feed out carpet (1) towards rear/top.
Cutting edges (1) shown on removed carpet (2).
Replacement:
Place removed carpet on new carpet and carry over cuts to new
carpet.
Installation:
Apertures (3) serve as alignment points for fitting the carpet (2).
Replacement:
Detach stowage net (1).
Remove clips (2) for stowage net (1).
RA Removing and installing/replacing front carpet for passenger compartment
BMW AG - TIS
04.02.2013 23:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
