X Series E83 X3 2.0d (N47) OFFRD
12 41 020
Removing and installing/replacing starter
(N47)
Necessary preliminary tasks:
•
Switch off ignition
•
Disconnect battery negative lead
•
Remove underbody protection
Pull off plug (1).
Unfasten nut.
Tightening torque 12 52 3AZ
.
Remove battery positive lead (2).
Release screws.
Remove starter.
Installation:
Observe screwing sequence.
Position starter. Tighten down screws (1 & 2). Tighten down
support screw (3).
Tightening torque 12 41 1AZ
.
Installation:
Check starter pinion and ring gear for damage, replace starter
motor if necessary.
RA Removing and installing/replacing starter (N47)
BMW AG - TIS
05.02.2013 22:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -