X Series E83 X3 2.0d (N47) OFFRD
31 60 000
Removing and installing/replacing left or right
output shaft
Special tools required:
•
31 5 110
Remove front wheel.
Important!
Expand turning lock sufficiently to avoid damaging thread
when releasing collar nut.
Release collar nut; to do so, press brake pedal to floor.
Installation:
Replace collar nut, oil collar nut/wheel bearing contact surface
lightly and tighten down.
No oil permitted on thread of shaft journal or collar nut.
Tightening torque 31 21 2AZ
.
Secure collar nut by positive peening on flat areas of output shaft.
Remove reinforcement plate.
If necessary, remove steering gear cover at side
Remove tie rod end from swivel bearing.
Remove guide joint from swivel bearing.
Remove control arm from swivel bearing.
Remove stabilizer link from stabilizer
Remove front pulse generator from swivel bearing.
Important!
Risk of damage!
Do not drive output shaft out of drive flange with an impact
tool.
Turn swivel bearing to one side.
Press output shaft out of drive flange.
RA Removing and installing/replacing left or right output shaft
BMW AG - TIS
06.02.2013 00:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -