X Series E83 X3 2.0d (N47) OFFRD
33 31 000
Removing and installing complete rear axle
carrier
Special tools required:
•
33 4 420
Necessary preliminary tasks:
•
Remove emergency wheel pan
•
Remove propeller shaft from rear differential and tie back
•
Disengage handbrake Bowden cables from handbrake lever
and expose up to rear axle carrier
•
Remove coil springs
•
If necessary, disconnect plug connection from ride-height
sensor
•
Remove lip on both sides
•
Disconnect plug connection for pulse generator on both sides
•
Disconnect plug connection for right brake pad wear sensor.
Important!
Risk of damage!
Brake hose must not be exposed to tensile loads.
Release screw and remove bracket with brake hose.
Tightening torque 34 32 3AZ
.
RA Removing and installing complete rear axle carrier
BMW AG - TIS
06.02.2013 01:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -