X Series E83 X3 2.0d (N47) OFFRD
51 31 021
Removing and installing/replacing rubber
frame for windscreen (top)
Necessary preliminary tasks:
•
Remove both gutter strips on windscreen
Important!
Rubber frame (1) features an aluminium section inlay (2).
Detach adhesive tape on outside from windscreen and at top
from roof outer skin.
Carefully unwind rubber frame (1) (windscreen breakage).
Note:
Spacers (8) are attached to rubber frame (1).
Tear-off lip (5) may be stuck to adhesive (4).
When rubber frame (1) is removed, tear-off lip (5) can tear off
and remain in vehicle.
Attach adhesive tape correctly in area (A).
3
Windscreen
6
Bridge
7
Pinched butyl
Installation:
In area (A) on left/right:
-
there is no sealing lip (5)
-
there is adhesive tape (7) for windscreen (8)
-
buffer stop is moulded on
When replacing without removing windscreen:
Detach tear-off lip (3) from rubber frame (1).
If adhesive leaks over tear-off lip (3), this area must be cut out
partially.
To facilitate installation, coat rubber frame (1) and body cutout
with water.
Replacement with removed/new windscreen:
Fit rubber frame (1) with tear-off lip (3).
2
Aluminum strip
4
Butyl
RA Removing and installing/replacing rubber frame for windscreen (top)
BMW AG - TIS
06.02.2013 05:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -