X Series E83 X3 2.0i (N46) OFFRD
Adjusting camber:
Remove protective cap.
Knock out centering pin (1) in downwards direction.
Clean wheel arch from below in area of support bearing with
compressed air.
Slacken nut (2) approx. 1 to 1.5 turns.
Insert special tool 32 3 140 into wheel arch opening and over
nut.
Replace nuts (1) and screw on but do not tighten down fully.
Turn nut in special tool 32 3 140 using open-end wrench (2) to
adjust camber to specified value.
Tighten down nuts (1).
Tightening torque 31 31 1AZ
.
Remove special tool 32 3 140 .
Replace nut (1) and tighten down.
Tightening torque 31 31 1AZ
.
After installation:
•
Check directional stability of vehicle; if necessary, repeat toe-
in adjustment
RA Adjusting toe-in and camber on front axle
BMW AG - TIS
08.02.2013 06:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
