X Series E83 X3 2.0i (N46) OFFRD
32 31 070
Removing and installing / replacing lower
section of steering spindle
Important!
If the lower section of the steering spindle is separated from
the double joint/steering column, the steering column switch
cluster may be damaged when the steering wheel is turned.
Release clamping screw.
Move steering wheel to straight-ahead position and remove
ignition key.
Detach lower steering spindle from steering column and remove
with double joint towards bottom.
Installation:
Clean thread to remove all remnants of screw securing adhesive.
Replace clamping screw.
Clamping screw must rest in groove of steering column.
Tightening torque 32 31 1AZ
.
Release clamping screw (1).
Pull steering spindle lower section (2) from double joint.
Installation:
Clean thread to remove all remnants of screw securing adhesive.
Replace clamping screw.
Clamping screw must rest in groove of steering spindle lower
section.
Tightening torque 32 31 1AZ
.
RA Removing and installing / replacing lower section of steering spindle
BMW AG - TIS
08.02.2013 07:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
