X Series E83 X3 2.0i (N46) OFFRD
32 41 060
Removing and installing/replacing vane pump
for power steering (N46)
Important!
Follow instructions for working on cooling system!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off coolant hoses and hydraulic lines with plugs.
Necessary preliminary tasks:
•
Remove windscreen washer reservoir
•
Remove secondaray air pump
•
Draw off and dispose off hydraulic fluid from fluid reservoir
•
Remove steering fluid reservoir and place to one side
•
Drain and dispose of coolant from radiator
•
Remove belt pulley
•
Disconnect coolant hoses from thermostat housing and
thermostat
Release hose clamp (2) and detach suction line (1) from vane
pump.
Release banjo bolt (3) and disconnect pressure line (4).
Installation:
Replace sealing rings (D).
Tightening torque 32 41 3AZ
.
RA Removing and installing/replacing vane pump for power steering (N46)
BMW AG - TIS
08.02.2013 07:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
