X Series E83 X3 2.0i (N46) OFFRD
Slacken bolts (1)
Tightening torque 32 41 20AZ
.
Disconnect plug connection (2).
Release screw (3) and lay connecting line (4) with bracket to
one side.
Tightening torque 32 41 1AZ
.
Release screws (5).
Tightening torque 32 41 1AZ
.
Remove vane pump with water pump and set down on front axle
carrier.
Remove screws (1).
Remove vane pump (2) from water pump (3) and remove
towards top.
Installation:
Replace O-ring on water pump connecting piece and coat with
coolant.
Align vane pump shaft (2) to mounting on water pump (3).
Important!
Make sure connector is correctly seated in crankcase.
Connector must not jam when inserted!
After installation:
•
Add coolant and hydraulic fluid
•
Vent cooling system and checking for water leaks
•
Bleeding hydraulic system
•
Check pipe connections for leaks
RA Removing and installing/replacing vane pump for power steering (N46)
BMW AG - TIS
08.02.2013 07:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -