X Series E83 X3 2.5i (M54) OFFRD
12 51 001
Replacing wiring harness section for engine
(M54)
Warning!
Scalding hazard!
Only perform these tasks on an engine that has cooled down.
Necessary preliminary tasks:
•
Read out fault memory of DME control unit.
•
Switch off ignition.
•
Disconnect battery negative lead from battery.
Follow instructions for disconnecting and connecting battery.
•
E60 only: Remove microfilter housing lower sections on left
and right.
•
Remove cover for fuel injectors.
•
Remove intake air manifold.
•
Remove underbody protection at front and rear.
Note:
All illustrations show the E60/M54
Detach plug (1) from oil level sensor.
Unclip lead from cable tie (2) and lay towards top.
RA Replacing wiring harness section for engine (M54)
BMW AG - TIS
09.02.2013 16:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
