X Series E83 X3 2.5i (M54) OFFRD
32 31 219
Removing and installing/replacing double
joint with flexible disk
Important!
If the double joint is separated from the steering gear/lower
section of the steering spindle, the steering column switch
cluster may be damaged when the steering wheel is turned.
Necessary preliminary tasks:
•
If necessary, remove steering gear cover at side
Release clamping screw.
Move steering wheel to straight-ahead position and remove
ignition key.
Detach double joint with flexible disk from power steering gear.
Installation:
Clean thread to remove all remnants of screw securing adhesive.
Replace clamping screw.
Clamping screw must rest in groove of steering gear.
Tightening torque 32 31 1AZ
.
Release clamping screw.
Detach double joint with flexible disk from lower steering
spindle (1).
Installation:
Clean thread to remove all remnants of screw securing adhesive.
Replace clamping screw.
Clamping screw must rest in groove of lower steering spindle (1).
Tightening torque 32 31 13AZ
.
RA Removing and installing/replacing double joint with flexible disk
BMW AG - TIS
09.02.2013 20:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
