X Series E83 X3 2.5i (M54) OFFRD
33 32 071
Replacing one upper control arm
Note:
If the upper control arm is detached from the rear axle
carrier/trailing arm, it is necessary after reinstallation to carry out a
wheel/chassis alignment check.
Necessary preliminary tasks:
•
Remove coil spring
•
Remove stabilizer link from upper control arm
•
If necessary, remove jointed rod of ride-height sensor from
upper control arm
•
Support rear differential and remove from rear axle carrier
Unfasten nut.
Remove screw towards rear.
Installation:
Observe bolt insertion direction (F = direction of travel).
Replace self-locking nut.
Tightening torque 33 32 24AZ
.
Unfasten nut.
Remove bolt (1) towards rear.
Remove upper control arm (2) sideways.
Installation:
Note insertion direction of screw.
Replace self-locking nut.
Tighten bolt in normal position.
Tightening torque 33 32 14AZ
.
RA Replacing one upper control arm
BMW AG - TIS
09.02.2013 21:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
