X Series E83 X3 2.5Si (N52K) OFFRD
Remove inlet camshaft (2) towards top.
Installation:
Clean all bearing points and lubricate with oil.
Check plain compression rings (1) for damage and replace if
necessary.
Plain compression rings (1) are engaged at joint.
Press plain compression rings (1) apart upwards and downwards
and removed towards front.
Important!
Plain compression rings (1) can easily break.
Important!
Markings of inlet and exhaust camshafts are different.
Mixing up the inlet and exhaust camshaft will result in engine
damage.
A
Exhaust camshaft.
E
Inlet camshaft
Insert inlet camshaft (1) so that part number on twin surface
points upwards.
Position inlet camshaft (1) so that cams point upwards at an
angle.
Attach special tool 11 4 281 to twin surface.
RA Removing and installing/replacing inlet camshaft (N52K)
BMW AG - TIS
11.02.2013 08:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
