X Series E83 X3 2.5Si (N52K) OFFRD
Important!
Screw is not magnetic and must be secured against falling
down.
Release screw.
Remove magnet wheel (1).
Important!
Magnet wheel (1) is highly magnetic and must be protected
against metal filings/borings.
After removing, place magnet wheel (1) in a plastic bag (2) with
a seal.
Important!
Needle bearing (1) can break very easily.
Carefully pull needle bearing (1) apart at point of separation.
Remove all needle bearings (1) from eccentric shaft.
Install bearing shells (1) as pictured.
Note:
Always replace bearing shells (1) and needle bearings together.
RA Removing and installing/replacing eccentric shaft (N52K)
BMW AG - TIS
11.02.2013 09:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -