X Series E83 X3 2.5Si (N52K) OFFRD
32 00 620
Adjusting rear axle
Special tools required:
•
32 3 030
Note:
A camber change always means a toe change as well. The
camber must therefore be adjusted first.
Adjusting camber:
Replace nut (2) and tighten to 5 Nm.
Turn eccentric bolt (1) to adjust camber to setpoint value.
Tighten nut (2).
Tightening torque 33 32 25AZ
.
Adjusting toe:
Slacken bolts of bearing block by approx. 1 to 1.5 turns.
Attach special tool 32 3 030 to bolt head and pin (1).
Turn special tool 32 3 030 to adjust toe to specified value.
Tighten down bolts.
Tightening torque 33 32 13AZ
.
RA Adjusting rear axle
BMW AG - TIS
11.02.2013 12:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
