bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

2 RA Removing And Installing _ Replacing Rear Left Or Right Shock Absorber|Page 1141 > < 1 RA Information On Replacing Shock Absorbers
Page 1
background image

33 52 000

Removing and installing / replacing rear left
or right shock absorber

Note:

Read and comply with Information on replacing shock absorbers.

 

Necessary preliminary tasks:

Remove rear wheel

Remove luggage compartment panel on left and/or right

Warning!

Danger of injury!

Failure to comply with the following instructions may result
in the vehicle slipping off the lifting platform and critically
injuring other persons.

 

When supporting components, make sure that

the vehicle can no longer be raised or lowered

the vehicle does not lift off the locating plates on the
lifting platform

Support trailing arm with a workshop jack (1).

Release screw.

Installation:

Thrust washer (2) on rubber bearing must point to screw head.

Tighten bolt in normal position.

Tightening torque, 33 52 1AZ

.

Open and secure anti-drumming lining (1) in area of support
bearing.

Unscrew nuts (2).

Remove shock absorber with support bearing towards bottom.

Installation:

Replace self-locking nuts.

Tightening torque 33 52 3AZ

.

RA  Removing and installing / replacing rear left or right shock absorber

BMW AG - TIS

11.02.2013  13:50

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

2 RA Removing And Installing _ Replacing Rear Left Or Right Shock Absorber|Page 1141 > < 1 RA Information On Replacing Shock Absorbers