X Series E83 X3 2.5Si (N52K) OFFRD
Installation:
Check that sleeve (1) is firmly seated.
If sleeve (1) is loose, it must be replaced.
A sleeve (1) firmly seated in the windscreen wiper arm can be
reused.
Windscreen wiper arm with firmly seated sleeve (1):
Return wiper system to rest position. Push wiper arm (2) with
firmly seated sleeve (1) onto shaft and tighten down.
Observe tightening torque, 61 61 10AZ
.
Check setting of wiper arm (2).
To correct setting, replace sleeve (1).
Windscreen wiper arm with new sleeve (2):
Return wiper system to rest position.
Push wiper arm (1) with sleeve (2) onto shaft and tighten until
hand-tight.
Adjust position of wiper arm in question in rest position (measured
between wiper lip and top edge of cowl panel cover).
Then tighten down wiper arm and check position of relevant wiper
arm again.
1.
66
±
1.5 mm
2.
61
±
1.5 mm
Observe tightening torque, 61 61 10AZ
.
RA Removing and installing/replacing both windscreen wiper arms
BMW AG - TIS
11.02.2013 21:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
