X Series E83 X3 3.0d (M57TU) OFFRD
11 23 010
Removing and installing or replacing
vibration damper
Special tools required:
•
11 8 010
Necessary preliminary tasks:
•
Remove fan.
•
Remove underbody protection at front and rear.
•
Remove A/C compressor drive belt.
•
Remove alternator drive belt.
Detach exhaust bracket from transmission.
Slide special tool 11 8 010 into transmission opening (see
illustration).
Adjust special tool 11 8 010 at flywheel toothing. If necessary,
rotate flywheel a little.
Release screws (1).
Remove vibration damper (2).
Tightening torque 11 23 2AZ
.
Installation:
Replace screws.
Tighten screws crosswise.
RA Removing and installing or replacing vibration damper
BMW AG - TIS
14.02.2013 21:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
