bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

2 RA Removing And Installing Or Replacing Fuel Gauge Sensor (diesel, Right)|Page 591 > < 2 RA Removing And Installing Or Replacing Fuel Gauge Sensor (diesel, Right)
Page 2
background image

Necessary preliminary tasks:

Draw off fuel from fuel tank

Remove rear seat bench

Release screws (1) and remove cover (2) from right side of fuel
tank.

Unfasten plug connection (1) and disconnect.

Important!

Press the blue button to unlock the quick-release
fastener. Then carefully detach fuel feed line vertically
upwards.

Do not use any mechanical tools or means to detach the
quick-release fastener.

Quick-release fastener must be attached vertically
without mechanical tools/means. It must snap audibly
into place.

Then carry out a leak test with engine running.

Damaged or leaking quick-release fasteners must be
replaced.

Unlock and disconnect fuel feed line (2).

Unlock and detach vent line (3).

RA  Removing and installing or replacing fuel gauge sensor (diesel, right)

BMW AG - TIS

14.02.2013  22:40

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 2 -

2 RA Removing And Installing Or Replacing Fuel Gauge Sensor (diesel, Right)|Page 591 > < 2 RA Removing And Installing Or Replacing Fuel Gauge Sensor (diesel, Right)