X Series E83 X3 3.0d (M57TU) OFFRD
Release hose clamp and detach cooler retain line (1) from fluid
reservoir.
Installation:
Markings on cooler return line and fluid reservoir connection must
match up.
Release screws (1-3) and remove vane pump towards top.
Installation:
Make sure screws are installed in correct positions.
•
Screw (1) M8x80
•
Screw (2) M8x40
•
Screw (3) M6x85
Provisionally fasten vane pump (do not tighten down screws).
Tighten down first screws (1, 2) and then screw (3).
Tightening torque 32 41 1AZ
.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
RA Removing and installing/replacing vane pump for power steering (M47T2, M57TU, M5
BMW AG - TIS
15.02.2013 01:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -