X Series E83 X3 3.0d (M57TU) OFFRD
Important!
Clean end face (1) of drive flange and apply a thin coating of
grease.
Note:
Failure to comply with this instruction will result in the generation
of noise in the rear differential.
Installing drive flange:
Coat sealing lips of shaft seal and sealing surface of drive flange
with differential oil.
Attach drive flange as per marking.
Press on drive flange with special tools 23 1 300 , 33 1 341
and 23 1 303 , if necessary 23 1 302 until collar nut can be
screwed on.
Important!
Do not under any circumstances tighten down collar nut
beyond marker points in order to avoid damaging the
clamping sleeve.
Tighten down collar nut (1) to point where marker points are
aligned.
Drive in new retaining plate with following special tools (depending
on rear differential) as far as it will go.
-
168K/L, 188K/L: Use special tools 00 5 500 and
33 3 480
-
210 with lock, 215K: Use special tools 00 5 500 and
33 3 490
RA Replacing shaft seal for input flange on final drive
BMW AG - TIS
15.02.2013 02:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -