X Series E83 X3 3.0d (M57TU) OFFRD
33 32 160
Removing and installing/replacing
compression strut for rear axle carrier
Important!
Observe safety instructions for raising the vehicle
Driving without the compression strut is not permitted!
Necessary preliminary tasks:
•
Remove both tension struts
•
Lower exhaust system in rear area
Release screws (1) and remove heat shield (2).
Tightening torque 33 32 27AZ
.
Warning!
Danger of injury!
Failure to comply with the following instructions may result
in the vehicle slipping off the lifting platform and critically
injuring other persons.
When supporting components, make sure that
•
the vehicle can no longer be raised or lowered
•
the vehicle does not lift off the locating plates on the
lifting platform
RA Removing and installing/replacing compression strut for rear axle carrier
BMW AG - TIS
15.02.2013 02:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -