X Series E83 X3 3.0d (M57TU) OFFRD
Both O-rings must be fitted (water ingress).
Adjusting buffer stops:
If necessary, release lock nut (1) on buffer stop.
Note:
Nut (2) on guide remains tightened down.
Use Allen key to bring adjustable buffer stop into contact with rear
lid and then pretension by 1 turn.
Unscrew buffer stop until closed rear lid rests on buffer stops on
left/right sides.
Important!
The rear lid must not be higher than the side panels,
otherwise there is preload on height adjustment!
Note:
If the pretension results in poor rear lid closing comfort, the
pretension can be turned back to 0.5 turns.
Important!
Rear lid must not generate any noises while engine is idling
(pay particular attention to this in diesel models).
RA Removing and installing/replacing side left or right buffer stops on rear lid
BMW AG - TIS
15.02.2013 06:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -