X Series E83 X3 3.0d (M57TU) OFFRD
51 36 040
Removing and installing/replacing strip on
side window at rear bottom left or right
Special tools required:
•
00 9 318
Carefully lever out strip (1) with special tool 00 9 318 , starting
at front, in direction of arrow.
Installation:
Clean bonding area with adhesive remover (sourcing reference:
BMW Parts Service).
Air drying time: 1 minute
Important!
Adhesive areas must be dry and free of dust and grease.
Once it has been cleaned, do not touch the adhesive area
with bare hands.
Installation:
Stick double-sided adhesive tape (1) (sourcing reference: BMW
Parts Service) on middle of strip (2).
Remove protective film.
Press strip (2) firmly onto body (3).
Manual contact pressure: approx. 10 N/cm
2
Note:
Firm thumb pressure creates approx. 50 Nm/cm
2
.
Double-sided adhesive tape (1):
Measurement a=7.0 mm
Measurement b=0.8 mm
Replacement:
Adhesive tape (1) already attached to strip (2).
RA Removing and installing/replacing strip on side window at rear bottom left or ri
BMW AG - TIS
15.02.2013 06:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
