X Series E83 X3 3.0i (M54) OFFRD
Release screw cap with special tool 16 1 020 and remove.
Installation:
Tightening torque 16 14 2AZ
.
Installation:
Service cap can only be installed in one position.
When installing, make sure lug (1) of service cap engages in
corresponding opening (2) on fuel tank.
During torque tightening, notch (3) on screw cap can be
clearly heard and felt to engage toothed segment (4) on fuel
tank.
Replace rubber seal (2).
Important!
Make sure that tab (1) of adapter ring lies completely in
recess (2).
Carefully raise service cap (4).
Important!
Carefully release quick-release fasteners and detach.
Make sure quick-release fasteners are correctly engaged.
Test the quick-release fasteners by pulling on them.
Unlock and detach fuel line (2).
Unlock and detach vent line (3).
Disconnect connector (1).
RA Removing and installing or replacing fuel gauge sensor (petrol/gasoline, right)
BMW AG - TIS
16.02.2013 14:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
