X Series E83 X3 3.0i (M54) OFFRD
Remove line for pulse generator from spring strut.
If necessary, remove line for brake pad wear sensor from spring
strut.
Support swivel bearing (1) with workshop jack and a suitable
mounting.
Release nut and remove bolt (2) towards front.
Expand swivel bearing (1) with special tool 31 2 230 .
Lower workshop jack.
Remove swivel bearing (1) and tie up.
Installation:
Replace self-locking nut.
Tightening torque 31 31 3AZ
.
Installation:
Keep press fit of swivel gearing and spring strut in lower area
clean and free from oil and grease.
Spread swivel bearing (1) with special tool 31 2 230 , align by
means of gap to positioning pins (2) on back of spring strut and
raise as far as it will go.
Centering pin missing: Make position of studs in relation to wheel
arch.
Secure spring strut against falling out.
Unscrew nuts.
Remove spring strut downwards out of wheel arch.
Installation:
Align spring strut using centering pin (1) to bore (2) in wheel
arch or studs to wheel arch and push upwards.
Replace self-locking nuts.
Tightening torque, 31 31 1AZ
.
After installation:
•
Carry out wheel alignment check if a spring strut with support
bearing was or has been installed without centering pin.
RA Removing and installing complete left or right spring strut shock absorber
BMW AG - TIS
16.02.2013 16:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
