X Series E83 X3 3.0i (M54) OFFRD
Slide special tool 41 1 130 over assembly compartment partition
wall (1).
Tighten screws (2).
Insert stamp numbers 41 0 000 individually into die-plate.
Position spindle 41 1 133 centrally over stamp number
41 0 000 and tighten spindle to 20 Nm.
Repeat procedure for each number.
Note:
In the event of component or body replacement by the
workshops/garages, clearly delimit the vehicle identification
number at front and rear by stamping a "+" in place of the BMW
emblem.
Note national regulations.
RA Stamping vehicle identification number
BMW AG - TIS
16.02.2013 20:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
