X Series E83 X3 3.0i (M54) OFFRD
61 12 137
Replacing wiring harness for rear lid on right
Necessary preliminary tasks:
•
Disconnect battery negative lead
•
Remove trim for rear lid
•
Remove roofliner
Disconnect plug connection (1).
Feed wiring harness (2) out of rear lid.
Installation:
Correctly lay wiring harness (2).
Installation:
Make sure rubber seal (1) is correctly installed in groove on
frame.
Remove wiring harness sheathing in area (A).
Cut one cable after another at the appropriate point.
Connect cables of new wiring harness with butt connectors and
heat-shrink sleeves.
Insulate wiring harness with insulating tape and secure in place.
Installation:
Correctly lay wiring harness (2).
RA Replacing wiring harness for rear lid on right
BMW AG - TIS
17.02.2013 01:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
