X Series E83 X3 3.0Si (N52K) OFFRD
32 34 020
Removing and installing/replacing airbag unit
(from 09/2006)
Warning!
Observe the following instructions to avoid any risk of injury by
the airbag unit.
-
Comply with safety regulations for handling components
with gas generators.
-
Do not exert any force on the airbag unit.
-
Use only specified tools for releasing the airbag unit.
Note: Incorrect handling may result in triggering of the airbag
unit and thereby cause serious injury.
Important!
Steering wheel must be replaced if airbag unit has been
triggered!
Follow procedure after airbag triggering.
Necessary preliminary tasks:
•
Disconnect battery negative lead
Insert Torx screwdriver T30 (1) horizontally into opening on
reverse side of steering wheel until a spring resistance is felt
(approx. 4 cm).
Press spring leg (2) with Torx screwdriver (1) up to stop and pull
airbag unit away from steering wheel.
Repeat procedure on other side.
Installation:
Make sure electrical leads are correctly positioned.
Snap airbag unit with uniform pressing force plane-parallel in
direction of steering column shaft into steering wheel.
RA Removing and installing/replacing airbag unit (from 09/2006)
BMW AG - TIS
21.02.2013 08:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
