X Series E83 X3 3.0Si (N52K) OFFRD
33 53 000
Removing and installing / replacing rear left
or right coil spring
Important!
Both coil springs on the relevant axle must be replaced only in
the event of corrosion breakage!
Necessary preliminary tasks:
•
Remove rear wheel.
•
Remove output shaft from rear differential and tie back
•
Remove stabilizer link on both sides from stabilizer
•
If necessary, remove jointed rod from sensor lever of ride-
height sensor
Important!
Risk of damage!
Brake hose must not be exposed to tensile loads.
Release screw and remove bracket with brake hose.
Tightening torque 34 32 3AZ
.
Warning!
Danger of injury!
Failure to comply with the following instructions may result
in the vehicle slipping off the lifting platform and critically
injuring other persons.
When supporting components, make sure that
•
the vehicle can no longer be raised or lowered
•
the vehicle does not lift off the locating plates on the
lifting platform
RA Removing and installing / replacing rear left or right coil spring
BMW AG - TIS
21.02.2013 09:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
