X Series E83 X3 3.0Si (N52K) OFFRD
34 35 ...
Replacing a brake pad sensor (rear)
Important!
If a brake pad wear sensor that has already been ground has
to be replaced even though the minimum brake pad thickness
has not yet been reached, you must observe the following:
The new sliding contact must be filed down with a file to the
same length as the ground sliding contact.
Necessary preliminary tasks:
•
Remove rear right wheel
Release screws (1).
Release expander rivet (2) and remove cover (3).
Open cover (1).
Disconnect plug connection (2).
Disengage cable from holders (3).
Installation:
Ensure proper locking of the plug connector and proper seating of
the cable in the brackets.
RA Replacing a brake pad sensor (rear)
BMW AG - TIS
21.02.2013 10:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
