X Series E83 X3 3.0Si (N52K) OFFRD
65 77 016
Removing and installing/replacing airbag
control unit
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Warning!
Note airbag safety instructions!
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
•
Remove luggage compartment floor trim
•
Disconnect battery negative lead and cover
•
Remove center console
Unfasten plug connection (1) and disconnect.
Unscrew nuts (2).
Installation:
Before screwing down airbag control unit, make sure negative
lead (3) is resting on associated stud bolt.
Tightening torque 65 77 1AZ
.
Remove airbag control unit (4) in direction of arrow.
RA Removing and installing/replacing airbag control unit
BMW AG - TIS
21.02.2013 19:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
