Z Series E52 Z8 (S62) ROADST
11 13 010
Removing and installing/replacing upper oil
sump section (S62)
Special tools required:
•
00 0 200
•
00 0 201
•
00 0 202
•
00 0 204
•
00 0 206
•
00 2 030
•
11 0 260
•
31 2 220
Note:
To remove the upper oil sump section, the front axle
support must be lowered.
There is no need to perform a front axle alignment check.
Lift engine hood into assembly position.
Open cap (1), draw off hydraulic fluid from supply reservoir for
power steering pump. Dispose of hydraulic fluid.
Observe country-specific waste-disposal regulations.
Refit cap (1).
Detach supply reservoir from carrier.
Note:
Lines remain connected.
Remove upper section of intake filter housing (2) with air-mass
flow sensor.
RA Removing and installing/replacing upper oil sump section (S62)
BMW AG - TIS
06.02.2013 22:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
