Z Series E52 Z8 (S62) ROADST
54 34 005
Removing and installing/replacing hydraulic
unit for convertible top drive
Necessary preliminary tasks:
•
Remove wheel arch cover at rear left.
Caution!
Before hydraulic lines are opened, last opening and closing
operation of convertible top must have taken place no earlier
than 2 minutes beforehand.
Disconnect plug connection (1) and remove holder (2) from
installation frame.
Release screws (3). Swivel hydraulic unit with installation frame
out of installation position.
Installation:
Tightening torque: 54 34 2AZ.
Installation:
If necessary, replace bushing (1) with rubber penetration (2).
RA Removing and installing/replacing hydraulic unit for convertible top drive
BMW AG - TIS
07.02.2013 03:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
