Z Series E85 M roadst (S54) ROADST
Remove vane pump from timing case cover (lines remain
connected).
Unfasten screws and remove timing case cover.
Note:
Dowel pins for location purposes are pressed into the timing case
cover.
Installation:
Keep sealing faces clean and free of oil. Check dowel pins for
damage and correct installation position.
Replace seals.
Apply a thin coat of Drei Bond 1209 sealing compound (refer
to BMW Parts Service) to ends of seals at front and rear.
Position seals on dowel pins in timing case cover.
Installation:
Fit timing case cover with seals, insert all screws and
pretighten to approx. 5 Nm.
Fully tighten all screws in alternate sequence.
Tightening torque, 11 14 1AZ.
Caution!
Once all screws have been tightened down, retighten them in
a second operation.
RA Removing and installing, sealing or replacing timing case cover (S50 / S54)
BMW AG - TIS
06.02.2013 19:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
