Z Series E85 M roadst (S54) ROADST
Exhaust side:
Note:
Bearing caps are secured with adapter sleeves.
Bearing caps are marked A2 to A7.
Feed out bearing caps A2 to A7 and set down in order.
Exhaust side:
Important!
Exhaust camshaft must not tilt when tension is relieved on
special tool 11 4 380 .
Relieve tension on special tool 11 4 380 and remove.
Lift out exhaust camshaft.
If necessary, removing signal disk of exhaust and inlet camshafts:
Important!
Do not damage camshafts. Use protective vice jaws.
Grip camshaft at hexagon in a vise and release banjo bolt (1).
Installation:
Installation of camshafts and the VANOS adjustment unit is
described separately from removal. Assembly sequence for
removal and installation is different.
RA Replacing camshafts (S54)
BMW AG - TIS
06.02.2013 19:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -
